SRCDS Steam group


New to SRCDS
#1
Question 
I recently switched over from teh GUI dedicated server that comes with steam, to this srcds. The new server runs fine, and people are always joining it. But when it first starts up, or goes to a new map, i get a bunch of errors.

[Image: errors.jpg]
mzracer360.game-host.org:27015
Reply
#2
Thats really weird. I would suggest ( even though you may not want to do it ) erasing your SRCDS dir and downloading everything again.
Reply
#3
I have already done that once. I am still getting the errors. The server runs perfect though, its just very annoying when i start the server to have to go through all the errors before it starts.
mzracer360.game-host.org:27015
Reply
#4
You do have -game cstrike right? Those look like a lot of HL2 sound files.
Reply
#5
they are hl2 sounds, my server is a HL2 server.
-game "hl2mp"
mzracer360.game-host.org:27015
Reply
#6
Hmmm, I dont know what to tell you. Did you have errors downloading the files during your SRCDS install?
Reply
#7
i sometimes get an error or too, infact when i look in the console when im playing the game there are sometimes a couple of error messages

But ive never had a problem with server or client problems, all seems to work fine
Reply
#8
Yes, i did get an error, i couldn't even reinstall it at first. I got this error: Connection Reset, Winsock Error 10054 "connection reset by peer", but after a few times I was able to reinstall. All seems to work fine for my server too, but i'm still getting these errors.
mzracer360.game-host.org:27015
Reply
#9
Are you able to play on the server without missing important sounds? Can you play on your server in that state?
Reply
#10
I haven't noticed any missing sounds, that is unless i create an npc, they dont seem to have sounds Smile
mzracer360.game-host.org:27015
Reply
#11
mzracer360 Wrote:I haven't noticed any missing sounds, that is unless i create an npc, they dont seem to have sounds Smile
i aint had that error ....

try doing another update on ure install, see if that gets the missing files

also what command are u using ?
Reply


Forum Jump:


Users browsing this thread: 5 Guest(s)