Ubuntu server problems :(

[Noodles]

Hi all,

I've set up a srcds counterstrike source server on ubuntu server edition. Everything is installed well. but it will only listen to the 127.0.1.1 ip. Wich is pretty useless :p if added the command -ip 192.168.1.118 to the startup line. but then it says cannot assign requested adress.
Couldn't allocate dedicated server UDP Port, (even though I have forwarded every ports for this ip!) and then it restarts every 10 seconds!

Does anybody knows a solutions to this? maybe my network device is failing or something but I don't know. it's just built in on my mobo.

I hope I have given enough information.

Thanks for all the help!

Noodles

[bigtin]

http://www.oclc.org/support/documentation/ezproxy/technote/2l.htm

You could try that and add the IP to the interface properly.

[pengy]

Can you give us the output of ifconfig? And type ps ax |grep srcds_run

[Noodles]

I tried this howto. and I think that should work. but after I save the new configurations and try to restart the network interface it says:

* reconfiguring network interfaces
Don't seem to be have all the variables for eth0/inet
Failed to bring up eth0.

so the only output of the ifconfig command is the loopback interface.

hmm now I tried the command: sudo ifconfig eth0 up. but now it has it old configuration again so no static ip adress.

so the output of ifconfig is now

link encap:Ehternet HWaddr 00:13:8f:52:b2:04
inter addr:192.168.1.11 bcast:192.168.1.255 mask:255.255.255.0
inet6 addr fe80::213:8fff:fe52:b204/64 Scope:link
up broadcast running multivast MTU:1500 Metric:1
RX packets:6103 errors:0 dropped:0 overruns:0 frame:0
tx packets: 3541 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:6906509 (6.9 MB) TX bytes:203648 (203.6 KB)
interrupt:23 Base adress:0x2c00

[Noodles]

Also, I can't reach the server from my other pc's

[comradek]

Looks like your IP is 192.168.1.11 rather than 192.168.1.118.. is there a typo somewhere?

Try passing -ip 192.168.1.11 to srcds.

Also make sure that ports are being forwarded to the correct IP address!